31 Southern Cross 1978 Model Commissioned im 2014

Price Drop !!!! 39800

Southern Cross Commissioned in 2014 This is a Yacht Club Must !!
Unique Vessel Purchased in 1978 unfinished, Updated and Custom Built and Finished by Yacht Craftsman . Commissioned in 2014 NICE VESSEL ALMOST NEW
Design
The Southern Cross is a 1976 design by
Thomas Gilmer as a traditional, double-ended
cruising sailboat whose underbody has a fine
entry, firm midship section, and fine run aft.
The hull topside has a spoon bow, moderately
low freeboard, and a rockered sheer. It is
powered by a masthead sloop rig or a 24 hp
diesel inboard auxiliary. The deck has a trunk
cabin and aft cockpit for tiller steering. It is
typical of a type believed generally suitable
for alongshore and offshore cruising in
moderate weather with proper preparation,
adequate skills, and prudent seamanship.
Heat and Air
Mermaid thermostatically-
controlled ~8,000 btu reverse-
cycle heat pump with seawater
intake and AC water pump.
NAVIGATION-COMMUNICATION ELECTRONICS:
Cockpit:

• • Compass: In the bridgedecks aft face wKick Guard.

• • Multi-Nav: New 2015 Raymarine

• • Model I70 depth, speed, wind speed, AIS

• • Radar, GPS & Chart Plotter

• • 2015 B & G Zeus T12 touch-screen display and plotter with 4G antenna on mast face

• • Autopilot: 2014 Raymarine Tillerpilot with control head

Inside Navigation Station:

• • VHF Radio: New 2014

• • Standard Horizon Eclipse

Some Items New in 2014
Mast & Standing Rigging: Masthead sloop sailplan. Wood bowsprit with
stainless cap bolted to the stemplate area. White-painted Kenyon aluminum mast
stepped on the cabin top with a teak compression post carrying the loads to the top of
the ballast. Standing rigging appears to be the original 1978 stainless steel 1×19 wire
with swaged terminals at both ends, Nav-Tec
center-stud stainless turnbuckles at the
bottom end and stainless bar stock
chainplates bolted through the hull skin for
the stays and the bulkheads and hanging
knees or accommodation liner for the
shrouds.
 The rigging schedule includes a
bobstay, a replacement headstay inside the
roller furling, split back stay, cap shroud
through a single spreader, and forward and
aft lower shrouds to the spreader base.
Custom Interior built by a Yacht Craftsman .The Stairs over the Engine are Custom
Dining Table is Custom with 5 Different woods